Select Your Vehicle
GO
Clear

3000GT VR4 / Dodge Stealth AWD Transfer Case Input Spool Replacement

 The input spool on the 3000GT / Stealth AWD Getrag transmission/transfer case setup (W5MG1 / W6MG1) is very prone to corrosion and spline wear. Anytime the transfer case is removed the splines should be cleaned and have heavy grease applied to both the shaft coming out of the transmission (output shaft) and the splines inside […]

3000GT VR4 & Dodge Stealth Transfer Case Seal Installation Guide

After many years the Stealth or 3000GT VR4 transfer case seals begin to leak, this happened so often there was a safety recall in the 2000s to address the issue. The dealership would replace your seals and inspect your transfer case to see if it needed replaced completely. The recall has finally expired and very […]

3000GT / Dodge Stealth Transmission Shift Fork Roll Pin Walk-Out

The 1/2 shift fork on both the 5 and 6 speed has a real habit of having the roll pin walk out. Issues from this can range from missing gears to engaging two gears at once, which can be catastrophic to say the least! We loctite the pins in to help prevent this. The available […]

5 Speed 3000GT VR4 Getrag Transmission Rebuild Results

This unit needed some love when we received it, but its fully equipped now! We really enjoy rebuilding these AWD units for the 3000GT and Dodge Stealth turbos! 300M Output shaft New OEM Synchros New Seals New Bearings Fully cleaned All bearing pre-loads reset New 1/2 Hub and Slider New shifter bushing block New fill […]

3000GT Billet Transfer Case Build

We love to have the opportunity to build transfer cases from stock to maximum effort builds like this, but this unit came out so good we had to share! This 5 speed 3000GT transfer case build has the following: Full Rvenge Performance 3000GT Transfercase Rebuild Service REM Treated Gears Broomfield Racing Billet Case Vipershark Billet […]

Transfer Case Bearing Pre-loads – 3000GT Spool Swap

Bearing pre-loads are critical to long life of any tapered roller bearing. It is very important when swapping a transfer case spool to reset the bearing pre-load. A different spool than the original one your transfer case came with may not be dimensional identical and aftermarket spools, while often very high quality, may bring additional […]

3000GT / Dodge Stealth Performance Spark Plug Recommendations

Today we want to share some recommendations for what spark plugs to run, in terms of spark plug electrode material, spark plug heat range, spark plug gap, and other options. These recommendations are meant for modified cars, from BPU to wild. The stock or parts store plugs are acceptable for a bone stock 3000GT or […]

3000GT Rear End Rebuild Results

In this blog post we want to cover the results of a 3000GT rear end rebuild we recently performed. This rear differential from a 6 speed 3000GT VR4 needed a rebuild for many reasons. It was rusty, had excessive backlash, and the seals were leaking. We had a core in stock and rebuilt it on […]