Russell Full Flow Hose Ends are made from lightweight aluminum and are completely reusable. They feature a unique taper design ensuring easy assembly and also offer 37° angled sealing surface which guarantees a positive anti-leak seal. These Full Flow Hose Ends accepts a wide variety of lightweight aluminum AN style adapter and carburetor fittings. Lastly, these Russell Fittings are interchangeable with many other manufacturers' hose ends.
Russell Pro Classic Hose Ends are made from 6061-T6 aluminum and are completely reusable. They feature Russell's proven long taper design ensuring the ease of assembly. AN Standard 37 degree flare design. Russell Pro Classic Hose Ends work with all AN Male adapters. Use only with Russell Pro Classic hose for best results.
Verify hose series, hose size, AN size, and fitting angle before assembly. Cut hose cleanly, assemble the hose end according to instructions, and confirm the hose is fully seated. After installation, route away from heat, sharp edges, and moving components, then pressure check for leaks.
Standard Radius Full Flow 180 Deg. Swivel Hose End; Red/Blue; -10AN; Center Line Radius 1.25 in.;
Russell Performance -10 AN Red/Blue 180 Degree Full Flow Hose End (1-1/4in Centerline Radius)
10AN ProClassic 180 Degree 1-1/4" Radius Hose End With Red/Blue Finish
Interchangeable w/Many Manufacturers AN male adapters
Standard Radius Full Flow 180 Deg. Swivel Hose End
-10 PRO CLASSIC 180 DEGREE HOSE END RED & BLUE
Completely Reusable W Russell Pro Classic Hose
Interchangeable w/Many Manufacturers Ends
Traditional Red & Blue Anodized Finish
Russell's Proven Long Taper Design
Positive Anti-Leak Seal
Clamp-On Hose Fitting
Russell HOSE END
37 Deg. AN Flare
6061-T6 Aluminum
Hose Fitting
HOSE END
